PDA

View Full Version : 3rd Alternator in less than a year ??



Screw
05-01-2014, 06:06 PM
2006 V6 mustang , on Alt #4 in approx 2 yrs . Aftermarket stero , no amps , had stereo installed at so called professional shop . Alternator was replaced by an Auto electric shop in Newmarket . First alt was done before the stereo , and they have all been re manufactured units .Any thoughts from the gurus ?

ZR
05-01-2014, 06:14 PM
Not common on that car.
Has it had the battery go flat / boosted n run without charging the battery?
Has it been used to boost other vehicles from time to time?
On am start, does it act like the battery just has enough juice to start the engine?

Screw
05-01-2014, 06:20 PM
No boosting of other vehicles , has been boosted instead of charged , battery also replaced within the year . Remote start ...could a load of stereo on ,fan for heat or defrost on at start up affect amp draw ? I know I personally turn everything off on my truck before I shut er down , doubt he does .

ZR
05-01-2014, 06:25 PM
has been boosted instead of charged

So batt has gone dead?
If the battery is partially discharging overnight, puts a large load on the alt for an extended period of time bringing it back up to full charge. Rest of the stuff, not really a huge factor unless he's prone to over using high fan and is constantly using the defroster while driving (cycling it on till if goes off / repeating).

Screw
05-01-2014, 06:34 PM
Yes battery has gone dead , was boosted to try to get it going , till we discovered the alt . The first time I replaced it I just boosted it and did not charge before I fired it up .

ZR
05-01-2014, 07:53 PM
Usually take repeated flat n boosted to kill.
Feel it comes down to
-alt's rebuilt sub standard
-draw overnight, causes alt to constantly be overworked bringing batt back up to full charge
-engine and or body ground issue.

Just because it starts and runs does not mean there isn't a poor ground somewhere.

Screw
05-01-2014, 07:56 PM
10-4 , hopefully he finds something , if not .... shop of ZR ?

ZR
05-01-2014, 08:45 PM
Best to pull the engine ground off and clean, same for the body ground.
Just holler.

Screw
05-02-2014, 10:28 PM
So back from the shop , jr drives locally notices lights dimming so heads home , rests at bottom of driveway . Auto electric shop re re alternator, said cleaned up grounds . Put sct on and monitor voltage , restarts at 14v and drops to about 11 , lights dimming under revs and sparks shoot out of alt ... ?

ZR
05-02-2014, 10:32 PM
Alt is fubar.
What did they find with the old one?

Screw
05-08-2014, 08:09 AM
So buddy changed the alt again and replaced the battery ...he had the cars for a couple of days couldn't find anything . Was looking to install a volt gauge and came across this , any thoughts or overkill ?
http://m.americanmuscle.com/aeroforce-single-interceptor-0512.html

Blackmare
05-08-2014, 12:10 PM
So buddy changed the alt again and replaced the battery ...he had the cars for a couple of days couldn't find anything . Was looking to install a volt gauge and came across this , any thoughts or overkill ?
http://m.americanmuscle.com/aeroforce-single-interceptor-0512.html

Those are nice gauges. You'd be able to see more than just volt as well.

ZR
05-08-2014, 08:45 PM
Does the car have a gauge or a light?
Did he find anything beyond the alt fubar'd?

Screw
05-08-2014, 08:51 PM
Does the car have a gauge or a light?
Did he find anything beyond the alt fubar'd?

only a light ,no gauge , fnd a vent pod $31 from AM and either just pop in an Autometer gauge or spend a bit more for the Aeroforce .
Still no known cause of failure .:shrug:

ZR
05-08-2014, 08:52 PM
Cheapie volt gauge to keep tabs on it is all you need. Don't get steered into an amp gauge, volt tells all.

Slope
05-08-2014, 08:52 PM
only a light ,no gauge , fnd a vent pod $31 from AM and either just pop in an Autometer gauge or spend a bit more for the Aeroforce .
Still no known cause of failure .:shrug:

Is Gord taking care of you?

ZR
05-08-2014, 08:53 PM
Did he pull the grounds n clean regardless?

Screw
05-08-2014, 08:58 PM
Is Gord taking care of you?
He's certainly trying his best .

Slope
05-08-2014, 09:07 PM
He's certainly trying his best .

It's where my money goes when it comes to automotive electrical parts & service.

Spent a penny or two in there on go fast stuff too...

Screw
05-08-2014, 09:12 PM
It's where my money goes when it comes to automotive electrical parts & service.

Spent a penny or two in there on go fast stuff too...

Honestly he's been more than fair with me ,I do service in a different field so I know gremlins can be a bitch ! Can't say I've won em all either ,fingers crossed .

Screw
08-08-2014, 01:50 PM
#4 or 5 lost track , 06gtpony helped me track down a Ford alt , removed sanded cleaned grounds , shot in the dark removed sequentials went back to stock , fingers crossed . Still yet to instal my volts gauge maybe tomorrow ill give it a shot .

WHRDUGO
08-08-2014, 02:16 PM
Do the rebuids have the proper pulley installed? Maybe overspinning is eating them up.

Screw
08-08-2014, 02:21 PM
Never occurred to me to check ... this one is a Ford rebuild hopefully all goes well .

ZR
08-08-2014, 07:01 PM
Fingers crossed for ya. Grounds are well known to cause odd issues on the 197.

Screw
08-08-2014, 07:47 PM
Big wrenching for me , next a Volts gauge and I'm on my way to modding , ready to drop a 4.6 in it next lol

ZR
08-08-2014, 08:11 PM
Git er done.

jibbijib
10-12-2014, 10:39 AM
Trade it in for a fox. Problem solved.

Screw
10-12-2014, 12:25 PM
Trade it in for a fox. Problem solved.

I sold the car , been about a month and new owner hasn't had any alt issues ;)
Installed ford alt b4 I sold it .

jibbijib
10-13-2014, 01:45 PM
That's a better solution