PDA

View Full Version : Intercooler pump wiring



Uncle Buck
06-26-2014, 10:05 PM
Researching ways to power an intercooler pump on 2006GT. Common option is to add a keyed circuit and a relay but noticed the Roush install manual taps into the big connector beside the PCM. They simply take power from a red wire in this connector and run straight to the pump. See page 52&53

http://www.roushperformance.com/parts/manuals/Mustang-Supercharger-2005-2006-420112-manual.pdf

Anyone use this method? Think it's a good option?

ZR
06-26-2014, 10:48 PM
If it was mine, use that wire to trigger a relay. Pull power from the battery terminal on the fuse block, protect with a self resetting circuit breaker, done.

Scott
06-27-2014, 07:30 AM
Al, I am with Rick as I also recommend a relay and fuse in the circuit. Check out this page from LS1Howto, specifically Meziere Wiring w/Relay. Instead of taping into that wiring bundle you may want to consider a simpler key on source under the hood. I found a single wire and used a T-Tap.

http://www.ls1howto.com/index.php?article=26

Uncle Buck
06-27-2014, 08:05 AM
Thanks gents. Better to know what's in the circuit by making it yourself. The gauge of the wire Roush suggested using seemed too light anyway.