Printable View
ok so i had my motor rebuilt i had a new harmonic balancer installed proffesional products part#ms8007.the problem now is the crank pulley does not line up about a inch in to far has anybody else had this issue with a aftermarket balancer do i need to use a stock one?the supercharger is a vortech vsi.
If your talking small block Ford, spacers available to get you lined back up.
Found em on Summit. I'm sure any of the club sponsor speed shops could get what you need.
http://www.summitracing.com/int/sear...pulley-spacers
tks rick any tricks on how to get the proper measurment? This was suppose to be a simple rebuild turning into a large headache! tks again bobQuote:
Originally Posted by ZR
1- Look at P Products site to see if they show the correct one
2- If not, look at the spacers available, figure out roughly what you need. Find something the thickness you figure is required (stack of washers or perhaps a next size up nut), gently snug the pulley and use a straight edge from the water pump to measure where your at. Adjust plus or minus until your dead on, order the correct spacer.
you could hang a plum bob off the supercharger pulley and then use a straight edge of the balancer to get your measurement in inches. Had to do this for a buddys car.
tks again e mail sent to them.Quote:
Originally Posted by ZR
tks again guys we have a great group.special tks to scott for maching the spacer for me.
Good deal, not get it finished up will ya.
that's the plan. i'm more then antzy to get behind the wheel againQuote:
Originally Posted by ZR