What colour should I powder coat my power steering bracket and alternator bracket?
Chrome
Black
Silver
Yellow
Other
https://uploads.tapatalk-cdn.com/201...b0a94c542d.jpg
Sent from my iPhone using Tapatalk
Printable View
What colour should I powder coat my power steering bracket and alternator bracket?
Chrome
Black
Silver
Yellow
Other
https://uploads.tapatalk-cdn.com/201...b0a94c542d.jpg
Sent from my iPhone using Tapatalk
What are the reasons for the colour options?
It's a bracket, not something I think you need to highlight, so yellow and chrome are out.
Hey look........I have a BRACKET. go black so it will be clean and not seen
Black gets my vote. Can I suggest that you deburr any bumps or flashing on the part first. It will show through after powdercoating and will look less appealing.
That was my plan. I was considering polishing it but I feel it will be a nightmare to keep clean.Quote:
Originally Posted by Scrape
Sent from my iPhone using Tapatalk
I am open to other options also. I have no reason, I just want it to look cleanQuote:
Originally Posted by Ponyryd
Sent from my iPhone using Tapatalk
I’d just clean it good and spay it with dark grey or flat-black, I wasn’t sure if maybe you had those other colours elsewhere on the car.Quote:
Originally Posted by 1986stangfan
If it was me I’d probably take it to the wire wheel and leave it as-cast, paint can chip, scratch, peel, etc....
Grey hammer tone would be a nice option.
Yep, clean, sand smooth and paint satin black ��
Got the alternator bracket all de-burred so far. Now I need a power steering pulley puller to get the ps bracket off.
Sent from my iPhone using Tapatalk
I like the look of chrome/silver....but I'm a bit bias. And yes...I haven't done my bracket yet.
Attachment 12339
Finally an update here. Went with wrinkle black https://uploads.tapatalk-cdn.com/201...da648a9c57.jpg
https://uploads.tapatalk-cdn.com/201...e0ebf5579a.jpg
Sent from my iPhone using Tapatalk
I have a pulley puller you can borrow if needed.
That would be fantasticQuote:
Originally Posted by 1quikgt
Sent from my iPhone using Tapatalk
I live in Bowmanville behind the Walmart. I’m home every evening after 7 during the week if you would like to pick it up? Pm me and we can work something out.
Wrinkle black definitely looks good, but is it going to be hard to keep it clean with the rough surface?Quote:
Originally Posted by 1986stangfan
It almost feels like a Teflon coating. I suspect it will clean easilyQuote:
Originally Posted by Scott
Sent from my iPhone using Tapatalk
Hi Mike.......Like the blower that I Found for you!!!
But so not a fan of the bracket!
To me me ....just does not look right!
not to bad i did my finned valve covers years ago and it wasnt that hard i loved that look even sanded the fins si they were polished
Haha thanks again for passing the info along on that blower.Quote:
Originally Posted by machinedoc
Honestly it looks 100000x better in person. The photos make the wrinkle black look odd