Fox body under hood insulation with STB/TFS intake?

I was wondering if anybody has the stock hood liner with an aftermarket intake/STB? Mainly wanna know if it fits? I want to put one on to reduce noise/heat.. But don't want to waste the cash if it won't fit.
Anybody got any insight for me on this?
Thanks!

have all the above on mine, no issues.

Mine touched when I had the combo but I may have had a spacer in there at the time (with an Edelbrock Performer 5.0 intake). The STB was a 4-point so no problem with clearance.

Quote:

---

Originally Posted by 92redragtop

Mine touched when I had the combo but I may have had a spacer in there at the time (with an Edelbrock Performer 5.0 intake). The STB was a 4-point so no problem with clearance.

---

I have a tfs track heat intake with a 1inch spacer, very similar setup as 1BAD92LX actually. When yours touched the insulation, did it cause any issues? Im sure it'll rub and maybe take scuff the paint on the intake maybe? but if thats its, im ok with that

Do you mean the fire suppression blanket? ;)

Sorry I couldn't resist.

I do not have a spacer. Might want to grab a ball of play-doh and close the hood and see how much room you have.

Quote:

---

Originally Posted by 90GT

I have a tfs track heat intake with a 1inch spacer, very similar setup as 1BAD92LX actually. When yours touched the insulation, did it cause any issues? Im sure it'll rub and maybe take scuff the paint on the intake maybe? but if thats its, im ok with that

---

Yes, it just scuffed the intake and had a little depression in the "fire suppression blanket" ;) but didn't seem to affect the hood.