Still alive.
Loading...
|
Type: Posts; User: swalt; Keyword(s):
Still alive.
You mean when my waterpump starts to sound like a Kenne bell, that is not good? I spend too much time maintaining the sleds.....the car just takes a back seat. Might have to give it a bit of love...
I feel like I have not been on this site for years.......I am sure many of you guys must think I fell off the face of the earth. Life got busy, family health issues popped up, car just sat other...
Thanks again guys. Brendan and I had a blast out there today.
Hey guys, I checked with Rick and he said I was good to post this up.
I just put my boat in storage, found a local person. He is located in a secluded area of Steeles and Trafalgar (I won't post...
If standard trans try a leather conditioner on the shift boot. Drove me nuts for months before I figured it out. It sounded almost line a scratching buzzing noise.
The moisture is sitting in one of the sensors or cap if it took a week for it to clear last time. The heat from the engine running alone should be good enough to dry anything out after 45 minutes,...
$75? Find a shop to order the part for you at jobber rate. I was like $25-30 for it three years ago.
I see way too many of you guys out there with the plates screwed right into the bumper. Clean it up a bit and throw a California Special plate mount on there. Last I checked they were about 30...
I had the Shaker500 and put the Kenwood Nav in a few years back. DNX-6140 and I have been very happy with it.
This is also a useful link to a link since you mentioned the car may have been in an accident before. Assuming new filter and the pressure sensor is good, there are several grounding points on the...
https://www.youtube.com/watch?v=gC0O1J4Am7E
I was going to get you a FPDM to swap in, but you already did that. You did the pump. Have you done the fuel filter? Second step (after calling my local Ford mechanic) said a faulty pressure...
I did the GT500 arms from American Muscle. Really nice when I order them from the states and the box says "Made In Canada" and I pay duties. They are much beefier than the stock GT arms.
As far...
Hemant, pull the carb off and bring it by my place. I will take it apart and put it in the ultrasonic cleaner for you. If you are unsure, pm me and I will pop by to pull it off and have it...
I think if you are after 07 you might have a chance of it being available in the programming to be enabled or disabled by the dealer. Prior to that you are pretty much SOL. I had the opposite...