Loading...
Remove Text Formatting

Likes Likes:  0
Results 1 to 3 of 3

Thread: What would you expect to pay - machining

  1. #1
    stangstevers
    Guest

    What would you expect to pay - machining

    Hi all, I’m trying to ballpark a 331 stroker kit. I think the rotating assembly will be around $2000 CAD but not sure on machining the block to get it cleaned up, decked? And open the bore 0.030 or whatever is needed.

    Is it like another 2 grand for machining? Lol hope not. Worst case I skip the stroker idea and just do a normal “306” freshening but I’d rather add more cubes while it’s all apart...

    Thanks

  2. #2
    Member
    Join Date
    Nov 2016
    Location
    Ajax
    Posts
    166
    '86 LX--5.2 Predator,TVS 2.65,built 6r80,308 gear,recaros,etc, 863 rwhp....@15 psi
    '03 Cobra DSG built 4v,TW cams,built t56.G-force axles ---3.0 Whipple 840 rwhp……….(18psi)
    '23 Ranger Lariat Splash.

  3. #3
    Member
    Join Date
    Oct 2017
    Location
    Ontario
    Posts
    310
    I havent had much machining done recently but if youre going to these lengths its probably not a bad idea to get the block magnafluxed while theyre opening up the bores etc....id imagine youre probably going to be close to another 1000 or better but again, its been a long time since ive had machining done.

    Sent from my LG-H873 using Tapatalk

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

SiteUptime Web Site Monitoring Service