Sucker For Punishment...

[Ray721]

Oops I did it again. Santa came a little early. Kooks 1"-7/8" Long Tube Headers and CATTED X-Pipe. Ok I learned a little bit with the Cats. But not much

Looking forward to installing them on jackstands this time around lmao!! I do have a rough idea of what to expect and this car has significantly less miles than my 06 did when I did them on it. Should be interesting! I also have an MGW race spec to install while I'm under there and a BOSS intake when I make it out from underneath it.

[RioCobra]

Oh man, nice present!

[ZR]

Nice haul Ray.

[MUSTANGWOP]

Nice haul Ray.

Agreed!

[RedSN]

How tall are these jackstands? Post progress pics (inc. bloody knuckles )
Braver than I, Ray. I've had long tubes hanging on my wall for almost as long as I've owned the car, LOL.

[fast Ed]

C'mon Don, longtubes on a Windsor engine are a walk in the park compared to doing them on a mod motor or Coyote!!

Get them done with the cyl. head swap in 2021.

[RedSN]

C'mon Don, ...Get them done with the cyl. head swap...

that was the plan.
...second thoughts now tho with ground clearance driving onto the lift.

[Ray721]

C'mon Don you have a lift. Tell you what. If I can get my lard ass under my car and do it on jackstands you HAVE to do yours before next season. Deal?

[newbiestangowner]

Very Nice Haul Ray!
I think you'll like the race spec.
hope to hear sound clip when you all done

[Minaccia]

Nice list of mods for the Coyote Ray but you are going to have a hell of a time installing those headers on your back with the car maybe 3 feet off the ground but it's possible. I installed my LT's last year with help from a friend and used his hoist and it still was a bitch to do but maybe with the stick cars there may be a little more room.

Use some Loc-tite on the stock nuts when bolting the new headers up, use the stock header gaskets so be careful not to damage them when you remove the stock headers, use some gasket maker on the stock header gaskets, remove the battery for better access and be careful when bending the aluminum A/C line to get to those header bolts on the right front .

While you're at it throw a 6r80 in there and then see how fast these Coyotes really are, lol.... Have Fun Ray and be patient cuz it's a hell of a job.