Post whatever is on your mind!!

[ZR]

Thanks. Yes I hope they settle some more. If not I may have to go with coil overs


Sent from my iPhone using Tapatalk

Nicely done.
If it happens, you won't regret coilovers.

[CDNfyrfytr]

Same as I’ve had. Didn’t replace them. They are Steeda I believe.


Sent from my iPhone using Tapatalk

[ZR]

Thanks all you " Street Takeover" fuckface twatwaffles for this one. Congrats on destroying a hobby even further attempting to elongate your penis through destroying knock off Chinese tires on your Scion FRS in a fucking active intersection...

^ Quoted for truth. Make trips on the 401 daily, even cruising 120 ish, come up on me like I'm standing still + one reckless lane change after another.

[Zippy]

Thanks. Yes I hope they settle some more. If not I may have to go with coil overs


Sent from my iPhone using Tapatalk

If they settle more you will need to recheck the alignment. Will make it toe out.

[dismark]

Hey guys. I need a professional opinion here. How and where do you usually check a service history of a vehicle before making a deal (online, official dealer?). I had my car for almost 10 years now and i think its a time for a change. I found few decent options and would like to do a VIN check now. Can someone recommend a reliable source? (Australia)
Update: found one - https://www.quickrevs.com.au/revs-check-nsw. Someone on this forum recommended it and i am very grateful for this, works well, easy to check and not expensive at all. Thanks to the guys who spend their time sharing so much useful information and ideas!

[mavrrrick]

Shout out to DaSilva’s. Thanks for getting a/c fixed up in record time!! Really impressed at clean up after, perfect!! Thanks again!!


Sent from my iPhone using Tapatalk

[ZR]

Ecoboost F150.
With JLT catch can in place, testing difference in accumulation doing 5000km changes + 10w30 full synthetic. Only took part of one 5k cycle to see it go from can 2/3 full of puke looking sludge to just a dusting of oil on the bottom.

[Zutz2v]

When doing break pads, should I replace the slotted and drilled rotors as well ?


Sent from my iPhone using Tapatalk

[xeninworx]

Not really unless they’re thin.

[ZR]

Pads will not fully / proper bed into anything but a fresh rotor surface meaning freshly machined or new. However most times they bed well enough.