Post whatever is on your mind!!

[ZR]

[Laffs]

Chasing down problems on one that won't etest, so far found, air temp sensor reading -40 (bad connector pin), MAF was causing intermittent lean (replaced), plus MAF block off plate on the CAI was mfg installed backwards leaving a 1/8" air gap. Got it down to one soft / no hard codes but needs more driving to see if it'll go ready before eng light flashes.

When can I ship mine to you?

- - - Updated - - -

You check fuel reg diaphram hasn't popped or maybe just seeping?

I pulled the vac line off it, don't see any fuel coming out of it tho, pressure at rail seems high but it is hot out.

[ZR]

Did you check actual fuel pressure?

[Laffs]

Yes sir. Was 50psi at rail idling when it was boiling hot under hood. Let it cool it was idling around 33psi. Did some data logging looks like my pump is putting out too much pressure, cars trying to pull the 25% maximum fuel out at cruising.

[ZR]

FPDM not idling the pumps back or running return?

[ZR]

Hot or not, should not be that high.

[ZR]

OR running boost a pump?

[Laffs]

Not sure on FPDM idling. Running factory returnless setup with a 340lph pump. No BAP

[Laffs]

I have a datalog of following

Time (sec) fp_duty_cycle fuel_rail_pr_psi idle_spd_valve load maf_counts short_term_b1 short_term_b2

[Scrape]

All long weekend was spent eating out for dinner with family and friends to celebrate my lovey wife's birthday! Happy Birthday to my wonderful wife. No more big meals. Gained 5 pounds at least this weekend!