Loading...
|
Likes: 3
My 99 GT seems to have a little lean to it. From the back it looks good, even and all that,but when I measure the wheel well, form the ground I get a 3/4 " difference?? I m wondering what that could be? It goes to the shop to be looked at in week or so... I was thinkin a cracked spring?? or something?? ... Passenger ft is about 26 1/4 , passenger ft is about 26 1/2... Driver side is about 26 1/2 ft and 27 7/8 at the bk....thats measuring at the tire, centre to the wheel well.... Any thoughts??
This is normal ... in my experience it's very tough to have a new edge sit perfectly even on all 4 corners from ground to fender lip. Even my cobra isnt perfect
? I just thought more than half inch is alot?? ... seemed like almost 3/4 inch depending on reading tape measure..
It's 100% normal on a Fox, somewhat common on New Edge.
My driver side rear is about 1/2 lower than the passenger side rear. These chassis weren't exactly the most rigid from factory. Driven spiritedly without major reinforcements will tweak them easily.
Originally Posted by ludacris
Even some never been driven hard virgin cars are out to lunch.
My 2004 had lean from new..
My 79 fox leaned about an inch on the right side - I've been doing some fab work and tried to correct it and it think it now leans to the left lol - I remove every piece of suspension and did t really see anything to cause the lean and think it is just fatigue
1979 Pace Car 302 4spd
1981 Cobra t-top option - power to be determined, in the works
Posting Permissions
Reply With Quote