Anybody have any experience with a MegaSquirt PNP2 with MS2 firmware? I just installed one due to the fact that after my last engine mod I had my car retuned and its felt like shit ever since. Finally got around to installing a wideband afr sensor and gauge to watch what was happening and it was all over the map as I suspected. Now with the MegaSquirt PNP2 it already cruises around better than before. I've got my idle dialled in pretty good already but I'm going to continue to make a few small tweaks here and there to try and make it even better. I've got my AFR table set, now just have to tweak the VE table and timing table. I've already got the timing table adjusted but just wondering if anybody has experience with this stand alone computer and can give some tips and tricks or advice.

Engine is a 347 stroker, AFR 185 heads that have been re-worked, Edelbrock Victor EFI intake, 70mm TB, no power adders yet, run on 94 octane only. About 10:1 compression or slightly lower.

'89 Fox body.