What did you buy today?

[xeninworx]

Needed a new cooler as my dad left our other big one in Montreal at my sister-in-law’s house. So I opted for least expensive and large capacity.

IMG_9539.jpeg

Wife wanted a new meat cleaver as our old one was dented, dull and the wooden handle came off. So you’re basically holding a metal handle while chopping.

Got this one from Amazon for $115. When looking for cleavers, pay attention to what they can cut through. Some are not meant to go through bone. This one does. Purchased based on reviews (4.5 rating) and price and warranty. I ain’t paying over $200 for a Zwilling.

IMG_9541.jpeg

[1BAD92LX]

BBK catted H pipe. Thanks Barone Performance!

[ZR]

Lou is da man.

[Zee]

A tattoo!

tatt.JPG

tattt.JPG

[R3troGT]

New shoes for the F150

356383354_3049110758566631_4456812810831112382_n.jpg
356918977_3049110761899964_1087070526638651601_n.jpg

[ZR]

^ Doesn't that change the look.

[Zippy]

20230628_212453.jpg

Ordered a weighted ball for my car

[ZR]

^ Nice purchase, no secret how much I'm enjoying wt'd ball from them in my own car.

[xeninworx]

Needed to replace my drives. Running out of space on C drive 120gb SSD, almost had no room to install WD cloning software. My D drive is a 1tb HDD and while still had 300gb left, was starting to get a little slower. My C drive is only for programs while I save everything on D.

IMG_9582.jpeg

This is my aging computer but runs well for run of the mill stuff, no gaming. Noctua dual fan for the processor. 200mm fan in front for intake. 200mm fans at the side and top for exhaust. 120mm fan at the bottom for intake. 120mm fan at the back for exhaust.

IMG_9580.jpeg

[Zippy]

Got something today that I've always wanted to have in the shop... a set of scales.
So excited to try them out on the DECH and mess around with them.
Big thanks to ZR for finding them for me
They are wireless scales from Intercomp. Have to setup the software on my laptop... then try em out.

intercomp_170154_pc_L__57897.jpg
20230708_125020.jpg