Likes: 
I’m swapping a motor (302 pushrod) that formerly had a 26 spline T56 mated and a Centerforce clutch. I’m reverting to a T5 ten spline tranny.
I no longer have any clutch model # info but the flywheel, clutch and pressure plate were bought as a kit and worked well for the 2500 KM’s I put on it before tearing apart again (for other reasons). Pressure plate says “Valeo” but no model #s
I’m re-using the motor but need a 10 spline clutch disk. Going to the Centerforce site I see 101 flavours of clutches and being somewhat uneducated don’t know which to select beyond 10.4” ten spline.
.The engine didn’t make it to Dyno prior to pulling. It’s stock block, fresh internals, Edelbrock E streets, extrude honed Cobra intake and if I recall about 10 lbs boost. I’m thinking 3-400 HP potential.
Any suggestions on which clutch disk would be suitable for a mostly street, track capable 3000lb Fox?
Reply With Quote