Rev limiter

[Broke]

I'm just wondering what some of you guys out there think is a good RPM to set my rev limiter. 02 GT 2V with stock bottom end (new), and comp cam stage 2 cams, with aftermarket springs. I have it set to 6400 right now, but it still feels like its pulling pretty hard when it hits the limiter. Just wondering if I could safely squeeze out another 500-1000rpm.

[99chromegt]

Go 7000 WTF... Get the f'n thing on a dyno! You're just rubbing salt in my wound because you can drive your car.

[Ray721]

Matt D revs his coyote to 8K...











I do not suggest doing this lol.

[ZR]

I'd have it dyno'd just for the sake of knowing where it falls off and adjust accordingly.

[Broke]

Go 7000 WTF... Get the f'n thing on a dyno! You're just rubbing salt in my wound because you can drive your car.

Lol... I'll be driving it to your place tonight.. Just gotta stop at Zehrs and grab some salt on the way. .... I agree that I should dyno it. Anytime you wanna pay for some dyno time, I'll be on it. Lol

[99chromegt]

Lol... I'll be driving it to your place tonight.. Just gotta stop at Zehrs and grab some salt on the way. .... I agree that I should dyno it. Anytime you wanna pay for some dyno time, I'll be on it. Lol

Just bring your porter cable and knee pads we can work out a deal lol

[Ghost Rider]

^^^okay the knee pads I get...


but porter cable?


lol

[Intmdtr]

That's some kinky shit going on there.

But you could probably raise the limiter to 6600 and see what happens. If you have upgraded springs you shouldn't experience any valve float.

[Broke]

That's some kinky shit going on there.

But you could probably raise the limiter to 6600 and see what happens. If you have upgraded springs you shouldn't experience any valve float.

I may try that. Do you think the stock bottom end would pose any issue? It's out of an 05 GT.

[Uncle Buck]

My 06 3V is set to 6700