Fox Mustang Tilt / Flip Front End

[tulowd]

Anyone done, seen or dreamed about doing this?

I have two tilt front end frame setups and have thought of building a one piece flip front end; but that is likely a pipe dream.
One is aftermarket universal, other one is a hood mechanism from a late 80's Buick LeSabre.


Anyone ?

[svo1990mustang]

The problem i see is the fox has so much front overhang that it would probably hit the ground before it would open enough to work on

[Intmdtr]

The problem i see is the fox has so much front overhang that it would probably hit the ground before it would open enough to work on

Unless you reinforced the lower clip and installed the mounting point lower on the front clip.

[Tailites]

Ive never seen it done on a Fox...certainly be the hot setup

flip front in carbon fiber...whoah!!!

[FoxRod]

You would need a one-piece front end like this perhaps?...



and a tilt hinge...


http://www.vfnfiberglass.com/8793mustang.htm

[Tailites]

You would need a one-piece front end like this perhaps?...



and a tilt hinge...


http://www.vfnfiberglass.com/8793mustang.htm

whoah!!!!!...awesome...where do you get cool stuff like this?

& of course the dumb answer to my dumb question would be...

klik on the link....

[Tailites]

shouldnt the hood & fenders be one?

[Slope]

whoah!!!!!...awesome...where do you get cool stuff like this?

Doesn't matter, you'd never spend the money.

[Tailites]

Doesn't matter, you'd never spend the money.

what if I sell the boat?

[Slope]

what if I sell the boat?

Shoulda done that this Summer when you said you were gonna...