351W advice

[Slope]

9.1 is the compression.

Based on this and the above, I'd be looking into a Comp Cams 270HR.

Either that or an XFI stroker (347c.i.) cam. 236HR would fit the bill.

I'd also try and put something on there other than the Cobra intake. If you were boosting right off the hop, it wouldn't matter so much. With N/A & low compression, the party will be over sooner than you expect.

[saleenman]

Thank you everyone.

Was thinking about this cam from comp cams. NX282HR-14. But really don't want to get into a new piston. Only reason I looked at that cam was because of a recommendation.

Will check the F and Z cam out.

[Laffs]

Yes stock stroke. 8.2 compression. Supercharger maybe down the road. Cobra intake.

Thanks Slope.

"maybe"

[Speedtospare]

Cobra intake

Almost a waste of time on a 351. It wont be able to keep up with the heads and it too small for anything than a 260 HP stockish 302. Cam choice is basically saying where you want the HP/TQ to work at a given RPM. Your probably choking 30-40 HP out of the combo.

[saleenman]

Thanks speed. So if superchargering the combo - cobra intake should do? It's kind of a special piece. That's why I'd like to keep the intake.

[Tailites]

Thank you everyone.

Was thinking about this cam from comp cams. NX282HR-14. But really don't want to get into a new piston. Only reason I looked at that cam was because of a recommendation.

Will check the F and Z cam out.

your main concern will be piston to valve clearance

no matter what anybody tells you will clear or not clear...you MUST always check

btw the intake will be fine on a SC 351...maybe not the best but ok