Anyone running 197 wheels on your SN95 / New Edge? If so, spacer you needed (heard it's 1")?
Loading...
|
Anyone running 197 wheels on your SN95 / New Edge? If so, spacer you needed (heard it's 1")?
You can borrow one of Ol Paint's 18" Bullitts if you need to check fitment.
Rick, a 1" spacer should be plenty, are you talking about OEM or aftermarket wheels? Typically the SN95 wheels are in the +24 to +30 offset range depending on width, and the S197 wheels are +45 to +50. If it's a 9.5" wheel, those are +45. So a 1" spacer will leave you at +20, which would fit on your car, but be out pretty close to the fender. What would probably be better is a 3/4" spacer, something like these, but then you would have longer studs all the time:
http://www.mustangwheelspacers.com/3...ndtools_1.aspx
cheers
Ed
plain white wrapper 12 GT500 coupe
Instagram: ed._nicholson
Your Ford dealer in the west GTA - Kennedy Ford Sales
www.kennedyford.ca - please use the Kennedy Ford SVT TMC account for parts inquiries
Also, a bit out of the way for you to come, but you are welcome to borrow one of the 9.5" Steeda wheels off my car to test fit, they are also +45.
cheers
Ed
Lots of good info, thanks Ed.
Link also shows they make a cool removal / installer, nice.
Only downside to the longer studs, would need open end nuts for my street wheels.
Was hoping the swap would use a 1" bolt on spacer, can't afford to be extra snug to the fenders on lapping days.
Built not bought! Follow this link to my 08 GT/CS Air Lift Performance Suspension Install Thread or this link to my Garage Thread
My biggest fear is when I die my wife will sell my car and parts for what I told her they cost!
Built not bought! Follow this link to my 08 GT/CS Air Lift Performance Suspension Install Thread or this link to my Garage Thread
My biggest fear is when I die my wife will sell my car and parts for what I told her they cost!