Clean-cutting hole saw for silicone couplers

[Old Fart]

Cool idea!

https://www.hagerty.com/media/maintenance-and-tech/wrenchin-wednesday-clean-cutting-hole-saw-for-silicone-couplers/?utm_source=SFMC&utm_medium=email&utm_content=Thursday_DailyDriver

https://i.postimg.cc/GmpRbkvk/DSC-0740-1.jpg

[Scrape]

That works!

[ZR]

Imagine if it slips.

[Gabe]

I am pretty sure I am never going to use that method

[ZR]

^ Once maybe, twice = no way.

[RedSN]

Imagine if it slips.
Hose clamps ...just to hold it while you weld it!

[hammerhead]

Don’t tell WSIB - pricks on a normal day in the real world of gettin’er done

[xeninworx]

Well that’s cool. I was going to make a custom intake tube when I had my Civic Si. Was going to swap the TB from the stock one to a V6 one as it’s direct bolt on and had drive by wire and 5mm bigger. But my HPS intake tube was too small. So would have to make a custom one. Figured it out to be that I would need 2 elbows, a 45 degree and 30 degree and have them coupled together to the TB to the airbox. Then cut holes for the ports.