ChickenLips
11-01-2021, 06:42 PM
I’m running new Cunnifer brake lines on one of my cars. The stock prop valve is gone and I’ll be using a manual biasing valve for the SN95 rears on the IRS.
My Q is routing on the drivers side line. Stock line goes under the frame rail.
I’ll be running to the Tee in the photo. I have some freedom to move the Tee somewhat.
I’m considering running the line through the larger factory hole in the strut tower. I’m talking about the hole the zip tie is routed through. It’s been a while since I’ve had suspension in, or an engine for that matter. Is there a reason not to route through the hole?
In case you’re curious I’m using moulding clay to position the Cobra master in it’s normal position with the booster removed. I packed the clay on the master with the booster in place and then removed the booster.
My Q is routing on the drivers side line. Stock line goes under the frame rail.
I’ll be running to the Tee in the photo. I have some freedom to move the Tee somewhat.
I’m considering running the line through the larger factory hole in the strut tower. I’m talking about the hole the zip tie is routed through. It’s been a while since I’ve had suspension in, or an engine for that matter. Is there a reason not to route through the hole?
In case you’re curious I’m using moulding clay to position the Cobra master in it’s normal position with the booster removed. I packed the clay on the master with the booster in place and then removed the booster.