PDA

View Full Version : S550 removed driver's lumbar support



dr.zed
03-20-2022, 05:02 PM
After reading multiple posts here on lumbar, I realized something. When I sit in the passenger seat it feels entirely different than the driver's seat, why? I would often feel that the lumbar in the driver' seat was "inflated" even when it was fully retracted. So I took the seat fabric off the back and disconnected the "throttle cable" in the lumbar and it fully retracted it and big difference! I've effectively removed what was poking in my back this whole time. This means the lumbar is not operational now. Getting into the back of the seat is a breeze, I worked from the back seat upside down and removed two electrical connectors and then the elastic bands holding the back fabric. With that away a trim pry tool will get two plastic push pins out then the back flap opens right up. Lifting up the flap and looking for the plastic pin that is seated in the metal hoop (see picture). With needle nose pliers, I squeezed the tabs together and pushed it out of the hoop. Once you release this, it releases the tension and you can see the sides of the lumbar retract. I connected the motor again (will it pop a code if disconnected?) and will disconnect the lumbar switch itself. Check it out.

HUGE difference!

28531
28532

xeninworx
03-20-2022, 06:26 PM
Wouldn’t throw any codes as some models don’t have lumbar.

ZR
03-20-2022, 08:17 PM
If it makes the seat more comfy for you, nice mod.

FABMAN
03-23-2022, 06:56 AM
Each to their own, but with my back having lumbar adjustment is pretty important.