Loading...
Remove Text Formatting

Likes Likes:  0
Page 1 of 2 12 LastLast
Results 1 to 10 of 14

Thread: 99 GT Tech Questions: WOT Box Or Other?

  1. #1
    99chromegt
    Guest

    Question 99 GT Tech Questions: WOT Box Or Other?

    Curious to know who is using a WOT box out there. I looked it up on line and found some info on it. I like the 2 stage limiter & no lift shifting options. What do you guys think the best option for having these functions are? Drag racing application on a street car. Is installation difficult? I believe some of these functions can be directly programmed into my custom tune without needing a WOT box. The addition of nitrous is also a consideration and needs to be factored in. Any thoughts?
    Should I not bother with this and just use a shift light only?
    Combo I'm thinking:
    WOT Box
    RAPTOR 2 Stage Shift Light
    Zex Wet Kit 100 Shot with supporting mods
    Drag Slick
    Also who sells WOT boxes?
    What drag slick is good & who sells them? Currently using MT ET Streets.
    Thanks
    Andrew

  2. #2
    Member Laffs's Avatar
    Join Date
    Mar 2014
    Location
    Windsor, ON
    Posts
    4,577
    http://www.npcompleteperformance.com/wotbox with http://www.npcompleteperformance.com/wotbox/nitrous would probably be what you are looking for.

    IMO, I think its overkill for your application, that said I thought Heinz ran one on the Red Shelby, idk.

    Slicks: Mickey Thompson, Hoosier, M&H are all reputable brands.
    Quote Originally Posted by ludacris View Post
    I'm Supercharged with the HideAway License Plate

  3. #3
    MEANMCHN
    Guest
    I know you can have the 2-step programmed into your superchip if that's what you're using.

    However I don't think it's really necessary since your right foot can do the same thing. I guess if you were bracket racing it would be good or were at the point where you were consistent down to the 10th it would be smart.

    I would probably opt for drag radials on your current setup, IMO a set of full slicks will slow you down. I've personally found that I'm about 0.2-0.3 slower on a set of slicks, sure I shave of 0.1 in the 60' but it hurts my MPH. I only make between 380-400 depending on the dyno, conditions, etc.

    Best I've ever run were on Nitto Drag Radials, 305 width at 24psi cold.

  4. #4
    99chromegt
    Guest
    My thinking behind the WOT BOX was to take the guess work out of it. After all an inexpensive mod for $200. I'm going to keep it old school foot, eye & brain action to keep it challenging for now lol. My setup isn't complicated or high HP.... I'm just paranoid after breaking the new 31 spline axle. I did just order my 2 stage Mini Raptor shift light. I will get Diago to program the launch mode RPM into my tune.

  5. #5
    TurboFox
    Guest
    Quote Originally Posted by MEANMCHN View Post
    I would probably opt for drag radials on your current setup, IMO a set of full slicks will slow you down.
    Not good advice.

    Drag radial on a stick car is asking for trouble

  6. #6
    MEANMCHN
    Guest
    Quote Originally Posted by 99chromegt View Post
    My thinking behind the WOT BOX was to take the guess work out of it. After all an inexpensive mod for $200. I'm going to keep it old school foot, eye & brain action to keep it challenging for now lol. My setup isn't complicated or high HP.... I'm just paranoid after breaking the new 31 spline axle. I did just order my 2 stage Mini Raptor shift light. I will get Diago to program the launch mode RPM into my tune.
    Drag radials might also be cheaper in the axle department There is also a 275 width drag radial class that would be good for your setup, lots of guys running some amazing times on them.

    Slicks are optimal, don't get me wrong, it's just a lot cheaper to spin tires than snap an axle/hurt a clutch/whatever. Especially as you're learning, I found slicks really unstable at the top end and I hate that feeling. Call me a pussy ha ha, I don't like walls, I'm allergic to them.

    As for the 2 step, depending on your chip you can have the 2-step programmed, but if I remember correctly you had to choose the rpm and it was set. From experience my launch rpm changes from 1900-2600 depending on the temperature.

  7. #7
    My Avatar is hot Intmdtr's Avatar
    Join Date
    Mar 2014
    Location
    Wasaga Beach
    Posts
    1,670
    Quote Originally Posted by TurboFox View Post
    Not good advice.

    Drag radial on a stick car is asking for trouble
    Drag radial on a IRS stick car is trouble.

    In all honesty though i think you are fine with the ET Streets you have now seen as they do have a bit of a softer side wall. I would invest the money in a better axle...as stated TEN hasn't given me the warm and fuzzy for a while now. Some Strange or Mosier axles would be a superior upgrade, and if you don't have them now some 3" ARP wheel studs too.
    "Without Warning, Without Conscience"


  8. #8
    My Avatar is hot Intmdtr's Avatar
    Join Date
    Mar 2014
    Location
    Wasaga Beach
    Posts
    1,670
    Quote Originally Posted by MEANMCHN View Post

    I found slicks really unstable at the top end and I hate that feeling. Call me a pussy ha ha,
    OK!!!

    I wouldn't call a slick unstable in the least. Its the person behind the wheel that gets unstable when they feel the rear end starting to dance around.
    "Without Warning, Without Conscience"


  9. #9
    WHRDUGO
    Guest
    I have a wot box. Nice simple piece to use and install. Programming is quick and painless. Mine has the shift light as well as nitrous controls. What they don't mention o's the anti theft feature when you remove the box the car will not start. I remove mine over the winter seasons.

    Perfect rpms at launch everytime and for me I built boost on the line that helps with the 60 ft. No lift is trick at first if you move your feet around cause when you find the pedal it trips it. I need to hack the switch off a tad

  10. #10
    Member Ray721's Avatar
    Join Date
    Mar 2014
    Location
    Bowmanville
    Posts
    1,686
    Did you only have slicks in the rear? I'm hearing that makes for an "interesting" ride. Add front runners and it's much more predictable.
    Follow me on Instagram @ray721_14gt for car pics and general shenanigans

    Because Rayscar!!!!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

SiteUptime Web Site Monitoring Service